Sierra Denali RWD V8-6.2L (2009)
The connector will back off of the electronic power steering control module smoothly as the connector cam lever moves towards it. Do not pull on the
connector until it is fully disengaged.
5. Push the connector cam lever (3) toward the rear of vehicle.
Note
Note the routing and any mounting points for the power steering assist motor electrical harness. Also note any other electrical harnesses that will need to
be re-secured to it after installation. Use new retainers and tie straps as needed.
6. Separate the power steering assist motor electrical harness retainers from the electronic power steering control module bracket and disengage the
electrical connectors (1).
7. Remove the engine shield. Refer to Engine Shield Replacement (See: Body and Frame/Frame/Skid Plate/Service and Repair/Engine Shield
Replacement) .
8. Remove the steering linkage shield bolts (1) and the steering linkage shield (2).
