Sierra Denali RWD V8-6.2L (2009)
1. Install the lower ball joint in the knuckle. Refer to Lower Control Arm Replacement (2500, 3500) (See: Control Arm/Service and Repair/Lower
Control Arm Replacement)Lower Control Arm Replacement (2500) (See: Control Arm/Service and Repair/Lower Control Arm Replacement
)Lower Control Arm Replacement (1500) (See: Control Arm/Service and Repair/Lower Control Arm Replacement) .
2. Install upper ball joint in the knuckle. Refer to Upper Control Arm Replacement (2500, 3500) (See: Control Arm/Service and Repair/Upper
Control Arm Replacement)Upper Control Arm Replacement (1500) (See: Control Arm/Service and Repair/Upper Control Arm Replacement) .
3. Install the outer tie rod end in the knuckle. Refer to Steering Linkage Outer Tie Rod Replacement (See: Steering/Tie Rod/Service and
Repair/Steering Linkage Inner Tie Rod Replacement) .
4. Install the wheel bearing and hub assembly. Refer to Front Wheel Hub, Bearing, and Seal Replacement (2500) ()Front Wheel Hub, Bearing, and
Seal Replacement (1500) () .
5. Install the wheel drive shaft, if equipped. Refer to Wheel Drive Shaft Replacement (2500) ()Wheel Drive Shaft Replacement (1500) () .
6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
7. Remove the support and lower the vehicle.
8. Verify the wheel alignment. Refer to Wheel Alignment Specifications (See: Alignment/Specifications) .
