Sierra Denali RWD V8-6.2L (2009)
1. Install the clutch pedal sub-assembly.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution) .
2. Install the clutch pedal to brake module bolts.
Tighten the bolts to 50 Nm (37 lb ft).
3. Install the clutch pedal to clutch pedal bracket bolt.
Tighten the bolt to 36 Nm (27 lb ft).
4. Remove the clutch master cylinder. Refer to Clutch Master Cylinder Replacement (See: Clutch Hydraulic System/Clutch Master Cylinder/Service
and Repair) .
5. Connect the clutch pedal engine start switch electrical connector (1).
6. Install the instrument panel. Refer to Instrument Panel Service Positioning (without SLT) (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair)Instrument Panel Service Positioning (with SLT) (See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Service and Repair) .
Warning
Replacement or reprogramming of the ECM, or replacement of the clutch pedal position sensor (CPPS) or clutch pedal requires that a CPPS learn
procedure be performed. Failure to perform the CPPS learn procedure may result in personal injury or damage to the vehicle or its components if the
vehicle is in gear and the starter motor is accidentally engaged.
7. Perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn (See: Manual
Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/Tremec 5-Speed (TZ0) - Manual Transmission)
orClutch Pedal Position Sensor Learn (See: Manual Transmission/Transaxle/Testing and Inspection/Component Tests and General