Sierra Denali RWD V8-6.2L (2009)
1. Install the clutch pedal position switch (2) to the pushrod.
2. Install the plastic retainer (1) tabs to the clutch pedal position switch (2).
3. Connect the clutch pedal position switch electrical connector (1).
Warning
Replacement or reprogramming of the ECM, or replacement of the clutch pedal position sensor (CPPS) or clutch pedal requires that a CPPS learn
procedure be performed. Failure to perform the CPPS learn procedure may result in personal injury or damage to the vehicle or its components if the
vehicle is in gear and the starter motor is accidentally engaged.
4. Perform the clutch pedal position sensor learn procedure. Refer to DTC P080A (See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/P Code Charts/P080A) orClutch Pedal Position Sensor
Learn (See: Manual Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/Tremec 5-Speed (M96) - Manual
Transmission) .