Sierra Denali RWD V8-6.2L (2009)
Shifter M/T: Service and Repair
Tremec 5-Speed (TZ0) - Manual Transmission
Transmission Control Lever Boot Replacement
Transmission Control Lever Boot Replacement
Removal Procedure
1. Remove the transmission control lever. Refer to Transmission Control Lever Knob Replacement (See: Tremec 5-Speed (M96) - Manual
Transmission/Transmission Control Lever Knob Replacement) .
2. Lift and push the lower edge of the control lever boot as necessary in order to expose the retaining screws
3. Remove the 4 control lever boot retaining screws (2).
4. Carefully release the 4 plastic retainers (3) from the floor and remove the control lever boot retaining bezel (1), boot (4), and retainers (3) as an
assembly.
5. Remove the 4 plastic retainers (3) in order to separate the control lever boot retaining bezel (1) from the boot (4).
6. Remove the control lever insulator (5) from the floor.
Installation Procedure
