Suburban 3/4 Ton Upper Ball Joint Replacement
5. New cotter pin (130).
^
Bend the pin ends against the nut.
6. Load the torsion bar, using J 36202.
^
Set the adjuster bolt at the mark made during disassembly.
7. Drive axle assembly (121) to the differential output shaft.
8. Bolts (135). Tighten bolts to 78 Nm (57 lbs. ft.).
^
Prelube steering knuckle seal.
9. Drive axle to the hub (114).
10. Washer (119 and nut (120). Tighten nut to 235 Nm (173 lbs. ft.).
11. Inner tie rod end to the relay rod.
12. Inner tie rod end nut. Tighten nut to 47 Nm (35 lbs. ft.).
13. Front splash shield.
14. Front splash shield bolts.
15. Tire and wheel.
16. Wheel nuts.
^
Lower the vehicle.
^
Check the front end alignment.
