Syclone V6-262 4.3L Turbo (1991)
3. Pulley (5) on the front head.
Installing The Pulley Bearing Assembly
-
Position J 33017 and J 33023-A over the inner race of the bearing.
-
Position J 8433-1 on J 33023-A and assemble the through bolts and washers through the puller bar slots and thread them into J 33026.
-
The thread of the through bolts should engage the full thickness of the compressor holding fixture.
Tighten
-
The center screw in J 8433-1 to force the pulley and bearing assembly onto the compressor front head (11).
-
Should J 33017 become misaligned with the inner race of the bearing, back off J 8433-1 and relocate center, then continue installation.
4. Pulley bearing retainer (3) using J 6083.
5. Clutch plate and hub assembly (2).
Clutch Coil