Syclone V6-262 4.3L Turbo (1991)
screws (10). Remove the six mounting screws (10) and special lock washers (9).
Installing The Rotor And Bearing Guide
Removing The Clutch Rotor Assembly
3. Rotor (6) and bearing (5) assembly using J 25031.
-
Place J 25031 down into the rotor until the puller legs engage the recessed edge of the rotor hub.
-
Tighten the puller screw against the puller guide and remove the clutch rotor and bearing.
Important
-
If the pulley rim mounting screws (10) and washers (9) were removed, only the clutch rotor and bearing assembly will be removed for
replacement. The clutch coil and housing assembly is pressed into the compressor and will not be removed unless the pulley rim mounting
screws are left in place and the pulley rim pulls the coil and housing assembly off with the clutch rotor and pulley rim assembly.
-
Place the clutch assembly face on wood blocks to remove the bearing.
Removing The Clutch Rotor Bearing
