Syclone V6-262 4.3L Turbo (1991)
Compressor Component View
Remove or Disconnect
Tool Required:
J 25008-A Compressor Holding Fixture
J 25031 Rotor and Bearing Puller
1. Perform steps 1 through 4 of "Clutch Rotor and Bearing Replacement" but do not loosen or remove the pulley rim mounting screws until the
clutch rotor, coil and pulley rim assembly have been removed from the front head. Be careful not to drop the Puller Guide J 25031 when removing
the assembly.
2. Pulley rim mounting screws and discard.
3. Slide the pulley rim off the rotor and hub assembly. The pulley rim and clutch coil are replaceable at this point.
Install or Connect
Tool Required:
-
J 26271-A Rotor and Bearing Installer
