Syclone V6-262 4.3L Turbo (1991)
one piece seal. Make sure that the seal seat and seal lip are free of lint and dirt that could damage the seal surface or prevent sealing.
Install or Connect
Tools Required:
J 33011 O-Ring Installer
J 23128-A Seal Seat Remover and Installer
J 34614 Shaft Seal Protector
J 5403 External Snap Ring Pliers
J 9625-A Pressure Test Fixture
Installing The Seal
1. New O-ring seal, dipped in 525 refrigerant oil, onto J 33011.
2. Insert J 33011 completely down into the compressor neck until it bottoms. Lower the moveable slide of J 33011 to release the O-ring into the seal
seat O-ring lower groove. (The compressor neck top groove is for the shaft seal retainer ring.) Rotate J 33011 to seat the O-ring and remove.
3. New shaft seal to J 23128-A.
-
Insert by turning handle clockwise, and then push J 34614, into seal lip. The stamped steel case side of the lip seal must be engaged with
knurled tangs of installer so that flared-out side of lip seal is facing and installed towards the compressor.
4. Shaft seal.
-
Place J 34614 over end of compressor shaft and slide new seal onto the shaft until it stops. Disengage installer from seal and remove J 34614
from compressor shaft.
NOTICE: Handling and care of seal protector is important if seal protector is nicked or the bottom flared, the new seal may be damaged during
installation.
5. New seal seat retainer ring using J 5403.
-
Insert new seal seat retainer ring with its flat side against the seal seat, using J 5403. Use the sleeve from J 33011 to press in on the seal seat
retainer ring so that it snaps into its groove.
Compressor Leak Testing
6. Leak test as necessary.
