Syclone V6-262 4.3L Turbo (1991)
INSTALL OR CONNECT
1. Press the new ball (69) joint into the lower control arm (40) using J-9519-D and locate the grease seal facing inboard.
2. Ball joint stud into the steering knuckle.
CAUTION: When fasteners are removed, always reinstall them at the same location from which they were removed and use the correct torque
value. If a fastener needs to be replaced, use a fastener of the correct size and strength. Failure to do so may result in component/system damage or
malfunction.
3. Stud nut (67) onto the stud and tighten to 113 Nm (83 ft lbs). Align the slot in the stud nut with the hole in the stud by tightening.
4. New cotter pin (68) to the stud.
5. Grease fittings and lubricate the ball joint until grease appears at the seal.
6. Caliper.
7. Wheel and tire assembly, then lower the vehicle.
8. Check the front end alignment.
Four Wheel Drive - 4WD
Hub, Knuckle And Ball Joints
