Terrain FWD L4-2.4L (2010)
8. Connect the left front brake pipe fitting (1) to the BPMV and tighten to 21 Nm (16 lb ft).
9. Connect the right front brake pipe fitting (2) to the BPMV and tighten to 21 Nm (16 lb ft).
10. Connect the EBCM electrical connector.
11. Install the accessory wiring junction block. Refer to Accessory Wiring Junction Block Replacement (See: Maintenance/Fuses and Circuit
Breakers/Fuse Block/Service and Repair/Removal and Replacement/Accessory Wiring Junction Block Replacement).
12. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic
Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair).
13. Turn the ignition switch to the ON position.
14. Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle).
15. Observe the brake pedal feel after performing the diagnostic system check. If the pedal now feels spongy, air may have been in, or may have been
introduced into the primary circuit.
16. If the pedal feels spongy, perform the Antilock Brake System Automated Bleed (See: Brake Bleeding/Service and Repair).