Terrain FWD L4-2.4L (2010)
Note:
*
DO NOT use any air tools to remove or install the guide pin bolts. Use hand tools ONLY.
*
Install an open end wrench to hold the caliper guide pin in line with the brake caliper while removing or installing the caliper guide pin bolt.
DO NOT allow the open end wrench to come in contact with the brake caliper. Allowing the open end wrench to come in contact with the
brake caliper will cause a pulsation when the brakes are applied.
6. Using a backup wrench to hold the brake caliper guide pin stationary, remove the brake caliper guide pin bolts (1).
7. Remove the brake caliper.
Installation Procedure
1. Install the brake caliper.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Hold the brake caliper guide pin stationary and install the brake caliper guide pin bolts (1) and tighten to 27 Nm (20 lb ft).
