Terrain FWD L4-2.4L (2010)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Pressure Modulator Valve Bracket Replacement
Brake Pressure Modulator Valve Bracket Replacement
Removal Procedure
1. Place the ignition switch in the OFF position.
2. Remove the accessory wiring junction block. Refer to Accessory Wiring Junction Block Replacement (See: Maintenance/Fuses and Circuit
Breakers/Fuse Block/Service and Repair/Removal and Replacement/Accessory Wiring Junction Block Replacement).
3. Remove the brake pressure modulator valve (BPMV) bolt (1).
Note: Do not pry on the accumulator caps on the underside of the BPMV.
4. Without disconnecting the brake pipe fittings, carefully lift the BPMV assembly (1) upward to release the mounting pins from the BPMV bracket