Terrain FWD L4-2.4L (2010)
7. Place blue dot (3) on the back of the radio control assembly to indicate that the radio control module has been reprogrammed.
8. Install the radio control assembly. Refer to Radio Control Assembly Replacement in SI.
Service Procedure Using the Radio Control Assembly Exchange Process
Caution
Insert a plastic body trim tool between the IP and radio control assembly along the top portion of the radio control assembly as shown in the illustration.
DO NOT use a flat-bladed screwdriver to remove the radio control assembly.
Note
If the customer is NOT experiencing any concerns with the center instrument panel (ICS), proceed to Step 1 and perform this recall. If the customer
DOES have ICS concerns, please contact the Technical Assistance Center (TAC) prior to performing this recall.
