Terrain FWD L4-2.4L (2010)
4. After the horn chirp has sounded and the right front turn signal is illuminated, repeat step 2 for the remaining 3 sensors in the following order:
1. Right front
2. Right rear
3. Left rear
5. When the left rear sensor has been learned and a double horn chirp has sounded, the learn process is complete and the BCM exits the Relearn
mode.
6. Ignition OFF, adjust all tires to the recommended pressures. Refer to Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label (
See: Application and ID/Vehicle Certification, Tire Placard, Anti-Theft and Service Parts ID Label).
Alternate DIC Relearn Enable Method
1. Apply park brake (manual transmission only).
2. Ignition ON, activate the Relearn mode with the driver information center (DIC) display controls. A double horn chirp sounds indicating the
Relearn mode has been enabled and the left front turn signal will also be illuminated.
3. Starting with the left front tire, activate the tire pressure sensor by using one of the following methods:
*
Hold the antenna of the J-46079 aimed upward against the tire sidewall close to the wheel rim at the valve stem location. Press and release the
activate button and wait for a horn chirp. Once the horn chirp has sounded, the sensor information is learned and the turn signal in the next
location to be learned will illuminate.
Warning
Over inflating tires may cause personal injury or damage to the tires and wheels. When increasing tire pressure do not exceed the maximum inflation
pressure as noted on the tire sidewall.
*
Increase/decrease the tire pressure for 8-10 seconds then wait for a horn chirp. The horn chirp may occur before or up to 30 seconds after the
8-10 second pressure increase/decrease time period has been reached. Once the horn chirp has sounded, the sensor information is learned and
the turn signal in the next location to be learned will illuminate.
4. After the horn chirp has sounded and the right front turn signal is illuminated, repeat step 2 for the remaining 3 sensors in the following order:
1. Right front
2. Right rear
3. Left rear
5. When the left rear sensor has been learned and a double horn chirp has sounded, the learn process is complete and the BCM exits the Relearn
mode.
6. Ignition OFF, adjust all tires to the recommended pressures. Refer to Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label (
See: Application and ID/Vehicle Certification, Tire Placard, Anti-Theft and Service Parts ID Label).
