Terrain FWD L4-2.4L (2010)
7. Position the wire seal to the terminal and crimp the seal and insulation using the J-38125-6 crimp tool, jaw 1 (1).
The completed terminal and seal should appear as shown above (seat back harness connector shown).
Note
Avoid getting solder on the terminal end or overheating the terminal.
Warning
DO NOT use soldering equipment that is battery or electric powered. These types of soldering irons can induce voltage into the circuit, which may cause
inflator module deployment and/or damage to electrical components. Use only the EL-28125-5A Ultra Torch or another butane fueled soldering iron
when working on SIR circuits.
8. Solder all four terminals at the wire crimp.
9. Slide the two body harness terminals through the opening of the orange connector position assurance (CPA) (1).
Important
Ensure that the appropriate wire colors match up (as noted in Step 4) when the connection is made between the seat airbag harness and
body harness.
10. Slide all four terminals (2) into the appropriate connector body as shown above. Install the blue terminal position assurance (TPA) devices onto
the connector ends.
11. Add NyoGel 760 Lubricant, P/N 12377900 (in Canada, use P/N 10953529) to the terminals on both sides of the connections.
