Terrain FWD L4-2.4L (2010)
Important
Note the wire colors on the seat airbag harness and body harness. Ensure that the wire colors are matched when installing into the new
connector.
4. Cut both wires from the body harness connector and seat airbag harness connector as close to the connector housing (1) as possible to minimize
wire length loss. Slide the conduit away on the seat airbag harness and remove just enough tape on the body harness to access the wires to install
the terminals and seals.
Important
Use caution when stripping insulation. Take care not to cut through the wire strands.
5. Slide the wire seals onto all four leads back enough to enable removal of the insulation. Install the blue seals (1) on the seat back harness and the
white seals (2) on the seat cushion harness. Strip the insulation off all four leads 5 mm (3/16 in). Align the seals with the wire insulation.
6. On the seat back harness, position two FEMALE terminals onto the wires. Caution must be used not to position the wire too far forward as it may
interfere with the mating portion of the terminal. Crimp the terminals on to the bare wire using the J- 38125-7 crimp tool, jaw E (1). Repeat the
procedure using two MALE terminals on the seat cushion harness.
