Terrain FWD L4-2.4L (2010)
7. Remove the control solenoid valve assembly (3) with transmission control module.
Caution: Use care when removing or installing the filter plate assembly. A broken or missing retaining tab may not adequately secure the filter
plate to the control solenoid valve assembly, resulting in possible damage or contamination.
8. Remove the control solenoid valve assembly filter plate (4). Discard the filter plate. It is not reusable.
9. Inspect the channel plate bolt pass through holes for damage or brinelling. Any damage will cause incorrect pressure switch operation. Replace as
necessary.
Installation Procedure
Caution: Use care when removing or installing the filter plate assembly. A broken or missing retaining tab may not adequately secure the filter
plate to the control solenoid valve assembly, resulting in possible damage or contamination.
1. Install a NEW control solenoid valve assembly filter plate (4) to prevent fluid leaks past the fluid seals.
2. Install the control solenoid valve assembly (3) with transmission control module.
3. Hand start the control valve body bolts (1, 2).
