Typhoon V6-262 4.3L Turbo (1993)
Wheel Speed Sensor: Service and Repair
Four Wheel Anti-Lock Brake System
Front Wheel Speed Sensor
1.
Raise and support vehicle, then remove wheel and tire assembly.
2.
Disconnect brake caliper assembly and position aside.
3.
On two wheel drive models, remove hub and rotor assembly.
4.
On four wheel drive models, remove rotor, then hub and bearing assembly.
5.
On all models, disconnect wheel sensor electrical connector.
5.
Remove sensor wire form upper control arm clip.
6.
Remove sensor and splash shield assembly attaching bolts, then remove sensor.
7.
Reverse procedure to install. On two wheel drive models, torque sensor and splash shield assembly to steering knuckle attaching bolts to 11 ft.
lbs.
Rear Wheel Speed Sensor
Fig. 58 Rear Wheel Speed Sensor
1.
Raise and support vehicle, then remove wheel and tire assembly.
2.
Remove brake drum.
3.
Remove primary brake shoe.
4.
Disconnect sensor electrical connector.
5.
Remove sensor wire from rear axle clip.
6.
Remove speed sensor attaching bolts, Fig. 58, then remove sensor by pulling wire through hole in backing plate.
7.
Reverse procedure to install. Torque speed sensor attaching bolts to 26 ft. lbs.
