Typhoon V6-262 4.3L Turbo (1993)
11.
Position replacement shift control cable (10) through floor panel.
12.
Install nuts (9) at floor panel. Tighten nuts (9) to 4.5 Nm (40 in. lbs.).
13.
Position shift control cable (10) into bracket at floorshift control (17) and install retainer (34) to secure. Install clip (33).
14.
Install console assembly. Refer to INTERIOR TRIM (SEC. 10A4) in this manual.
15.
Place control lever in "NEUTRAL".
16.
Raise and suitably support vehicle as described in GENERAL INFORMATION (SEC.0A) in the 1993 Sonoma and Jimmy Models Service
Manual.
17.
Direct shift control cable (10) under fuel lines (49), vehicle speed sensor harness (46), and brace (61), if necessary, and through the cable retainer
guide (59).
18.
Install clip (7) and cotter pin (8) connecting shift control cable (10) to transmission (35).
19.
Loosen cable attachment at shift lever.
20.
Rotate shift lever clockwise to park detent and then back to "NEUTRAL".
21.
Tighten cable attachment to 20 Nm (15 ft. lbs.). Lever must be held out of "PARK" when tightening nut.
22.
Lower vehicle.
23.
Check shift control cable (10) adjustment by rotating control lever through the detents.
24.
Connect negative battery cable.
