V 2500 P/U 4WD V8-350 5.7L (1987)
Intake Manifold Gasket: Technical Service Bulletins
Intake Manifold Gasket - Service Information
CHEVROLET NUMBER: 87-T-30
SECTION:
6A - Engine Mechanical
DATE:
December, 1986
SUBJECT:
INTAKE MANIFOLD GASKET SERVICE INFORMATION
MODELS:
1987 R, V, G, P WITH 5.0L OR 5.7L (VIN CODES H AND K) TBI ENGINES
FIGURE 1
Some early produced 5.0L and 5.7L TBI engines were built with stainless steel clips that fit over the intake manffold gasket at the intake ports (Figure
No. 1). These clips are used to separate the intake ports.
These clips must be reinstalled after any repair that requires the removal of the intake manifold gasket. Failure to reinstall the clips could result in
driveability complaints such as poor performance or engine miss. It is also necessary to add a "dab" of RTV sealant, P/N 1052917, or equivalent, to the
gasket to head parting line (See Figure No. 1). Clips that are damaged or lost can be replaced by ordering P/N 10074116.
