V 2500 P/U 4WD V8-350 5.7L (1987)
FIGURE 7
Procedure for selection of the lo and reverse selective backing plate (Figure 7)
1.
On a flat work surface, stack up the following lo and reverse clutch assembly parts:
-
1 waved plate
-
5 fiber plates and four steel plates (682), starting with one fiber plate and alternating with a steel plate
-
lo and reverse clutch support assembly (679)
2.
Apply an evenly distributed load to the top of the lo and reverse support assembly (679). Light pressure (5 lbs.) on the lo and reverse support
assembly (679) will provide the correct dimension for measurement. (CAUTION: Excessive pressure will start to flatten the wave plate resulting
in an inaccurate measurement.)
3.
Measure height of clutch pack from work surface to the top of lo and reverse clutch support (679). Refer to Figure 7, Dimension D.
