V 3500 P/U 4WD L6-292 4.8L (1987)
Wheels: All Technical Service Bulletins
Light Duty Truck Wheels - Balancing Recommendations
Number:
87-118
Section:
3E
Date:
April, 1987
SUBJECT:
BALANCING LIGHT DUTY TRUCK WHEELS
MODELS:
ALL LIGHT DUTY TRUCK MODELS
Whenever an off-vehicle wheel balancer is used, whether for measuring wheel runout or for balancing, the wheel must be installed on the balancer using
a cone through the back side of the wheel's center pilot hole. Locating in any other manner could result in erroneous measurements. Most wheel
balancing machines are designed for back coning. Some wheel balancers, however, are designed to front cone light duty truck wheels with large center
pilot holes. Comments have been received of this being done to 16 x 6.5 inch, 8 bolt, code "AA" wheels, P/N 14035374.
The pilot hole's front side on such wheels is not a controlled surface. Front coning on this surface could cause wheels to be incorrectly measured as
having excessive runout, or it could result in an inaccurate balance. If your wheel balancer calls for front coning, consult the equipment manufacturer.
Minor modifications can usually be made to allow back coning.
