V 3500 P/U 4WD V8-350 5.7L VIN K TBI (1988)
Removing The Bearing From The Pulley Rotor Assembly
4. Pulley bearing (25) from the pulley (26) using J 9398-A and J 8092.
^
Remove the forcing screw from J 33020 and with the puller fangs still in place in the pulley slots, turn the assembly upside down onto a flat
surface.
^
When removing the old pulley bearing (25) allow the staking to remain, then file away the old staked metal for proper fit when installing a new
bearing (25) in the pulley bore.
Install or Connect
Tools Required:
J 6083 Snap Ring Pliers
J 8433-1 Puller Bar
J 9481 Pulley Bearing Installer
J 29886 Threaded Driver Handle
J 33017 Pulley and Bearing Assembly Installer
J 33019 Bearing Staking Tool (with staking pin and retaining band)
J 33023-A Puller Pilot
J 33026 Compressor Holding Fixture
J 35372 Compressor Support Block