V 3500 P/U 4WD V8-454 7.4L VIN W 4-bbl (1988)
Installing The Pulley Rotor Bearing
1. Pulley (26) on J 35372.
NOTICE: Do not support the rotor by resting the pulley rim on a flat surface during bearing installation or the rotor face will be bent.
2. Pulley bearing (25) into the hub using J 29886, J 9481-A and J 35372.
^
J 33019 in the pulley bore.
Staking The Pulley Bearing In The Pulley Bore
^
Seat the pulley and bearing assembly on J 35372 to support to the hub under the staking pin location.
^
Strike the staking pin with a hammer until a metal stake, similar to the original, is formed down to, but not touching the bearing.
-
Position the stake pin after striking.
-
The staked metal should not contact the outer race of the bearing to prevent the possibility of bending the outer race.