W 3500 L4-5.2L DSL Turbo (2006)
6. Remove the oil drain adapter.
7. Install the O-ring to the fuel supply pump.
8. Align the slits as shown in the illustration.
9. Insert the stud bolts into the guides and temporarily tighten them.
CAUTION:
-
If the stud bolts (cylinder block side) have been loosened or replaced, apply Loctite 262 to the recessed portion of the bolts.
- Check that the round alignment mark (white paint) is positioned as shown in the illustration when viewed from the plug hole. If necessary,
reposition the gear.
- Tighten the stud bolts and the nuts to the specified torque.
Tightening torque
nut: 50 N-m (37 lb ft)
bolt: 76 N-m (56 lb ft)
10. Apply a light coat of engine oil to the O-ring.
11. Install the oil drain adapter to the plug hole. Tighten the bolt to the specified torque.
Tightening torque: 8 N-m (69 lb in)
