Yukon/Denali 2WD V8-4.8L VIN V (2005)
Front Door Window Regulator: Service and Repair
Module Replacement - Front Power Window
Removal Procedure
1. Raise and support the window glass.
2. Remove the trim panel.
3. Remove the water deflector.
4. Disconnect the harness from the electric window motor assembly.
5. Remove the 2 bolts that hold the window glass to the regulator.
6. Remove the bolts from the window regulator.
7. Remove the window regulator assembly from the door by folding both sides of the window regulator assembly together.
Installation Procedure
1. Position the regulator to the inside door structure. A slight twisting motion of the regulator is needed.
2. Ensure the regulator is positioned firmly in the door.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Place Permatex Threadlocker, Part Number 24200, GM P/N 12345382, onto the regulator bolt threads prior to tightening.
3. Install the bolts to the window regulator.
Tighten the bolts to 9 N.m (80 lb in).
4. Align the window glass to the regulator.
5. Install the bolts that hold the window to the regulator.
Tighten the bolts to 9 N.m (80 lb in).
6. Install the water deflector.
7. Install the trim panel.
8. Lower the window and inspect the operation.
