Yukon/Denali 2WD V8-4.8L VIN V (2005)
11. If necessary, use a chisel in order to separate the hinge from the pillar.
12. Remove the hinge.
13. Remove all of the remaining weld from the pillar surface in order to ensure a flush fit of the service hinge.
Installation Procedure
1. Repair any damage done to the pillar during the drilling or the removal.
2. Position the service hinge within the scribe marks on the pillar.
3. Center punch each bolt location on the pillar according to the service hinge.
4. Drill a 3 mm (1/8 in) pilot hole at each punch location.
