Yukon/Denali 2WD V8-4.8L VIN V (2005)
1. Install the rear corner garnish molding to the vehicle.
2. Press on the rear corner garnish molding in order to engage the retaining clips.
3. Install the rear upper garnish molding.
Garnish Molding Replacement - Rear Door Upper
Garnish Molding Replacement - Rear Door Upper
Tools Required
J 38778 Door Trim Pad Clip Remover
Removal Procedure
1. Remove expanding plastic fasteners at window latch close-out.
2. Using the J 38778, release the retainers from the retainer seats.
3. Remove the trim panel from the liftgate.
Installation Procedure
1. Align the retainers with the holes in the liftgate.
2. Apply pressure to the seat retainers.
3. Install the expanding plastic retainers at the window latch close-out.
Garnish Molding Replacement - Rear Upper (Tahoe/Yukon/Escalade/Suburban)
Garnish Molding Replacement - Rear Upper (Tahoe/Yukon/Escalade/Suburban)
Tools Required
J 38778 Door Trim Pad Clip Remover
Removal Procedure
1. Use the J 38778 in order to remove the rear upper garnish molding.
Insert the J 38778 and work along the front edge of the trim panel from one end to the other.
2. Remove the rear upper garnish molding from the vehicle.
