Yukon/Denali 2WD V8-4.8L VIN V (2005)
4. Remove the fasteners (1) from each side of the rear base.
5. Remove the roller bar/rear cross rail assembly (3) from the vehicle.
6. Remove the fasteners (4) from the side rail/rear base.
7. With an assistant, pull gently back on the carrier (1) in order to release the carrier from the supports.
8. With an assistant, lift the carrier assembly up and off the vehicle.
9. Remove the fasteners from the center supports.
10. Remove the center supports with pads from the vehicle.
11. Remove the rear base fasteners (2) from the vehicle.
12. Remove the rear bases with pads from the vehicle.
INSTALLATION PROCEDURE
1. Install the rear bases with pads attached to the vehicle.
2. Install the rear base fasteners (2).
