Yukon/Denali 2WD V8-4.8L VIN V (2005)
Seat Back Frame: Service and Repair
Seat Back Frame Replacement - Front
SEAT BACK FRAME REPLACEMENT - FRONT
REMOVAL PROCEDURE
1. Remove the seat from the vehicle.
2. Remove the head restraint and guides.
3. Remove the seat trim panel.
4. Disconnect the lumbar cable (6) underneath the seat cushion (disconnect the lumbar wire harness if equipped with power lumbar).
5. Remove the seat back trim cover and pad.
6. Remove the lumbar assembly (or power lumbar/bolster assembly if equipped).
7. Remove the seat belt retractor.
8. Remove the inboard pivot bolt (1).
9. Remove the recliner arm attachment bolts (2).
10. Remove the frame from the vehicle.
11. Transfer all necessary components to the new seat back frame.
INSTALLATION PROCEDURE
1. Position the seat back frame on the seat.
2. Install the recliner arm attachment bolts (2).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 53 N.m (39 lb ft).
3. Install the inboard pivot bolt (1).
Tighten the bolt to 35 N.m (26 lb ft).
4. Install the seat belt retractor.
