Yukon/Denali 2WD V8-4.8L VIN V (2005)
3. Unsnap the lumbar cable (6). Disconnect the lumbar wire harness if equipped with power lumbar.
4. Disconnect the electrical connectors.
5. Remove the pressure sensor (2) from the front passenger seat frame, if equipped with the Inflatable Restraint Passenger Presence System.
6. Lift the seat cushion up off the rear plastic holders (1) on the underside of the seat cushion, and pull forward.
7. Remove the seat switch bezel.
8. Remove the lumbar actuator (5).
9. Unclip the seat trim cover from the seat cushion frame.
