Yukon/Denali 2WD V8-4.8L VIN V (2005)
1. Install the door module into the switch panel bezel until it snaps into place.
2. Install the switch panel bezel and module into the door trim panel.
3. Install the screw (2) that retains the switch panel bezel (1) to the front door trim panel.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screw (2) to 2 N.m (18 lb in).
4. Install the front door trim panel.
5. Perform the necessary setup and programming procedures. Refer to Door Control Module Programming and Setup in Vehicle Control Systems.
