Yukon/Denali 2WD V8-4.8L VIN V (2005)
4. Remove the front seat heater switch assembly.
INSTALLATION PROCEDURE
1. Install the front seat heater switch assembly to the front trim panel by pressing the switch into place until the switch is completely seated.
2. Connect the electrical connector to the front seat heater switch assembly.
3. Install the front trim panel.
Heated Seat Switch Replacement - Rear
HEATED SEAT SWITCH REPLACEMENT - REAR
REMOVAL PROCEDURE
1. Remove the center console end panel.
2. Disconnect the electrical connector.
3. Remove the seat heater switch retaining screws.
4. Remove the switch from the vehicle.
INSTALLATION PROCEDURE
1. Install the switch to the console panel.
2. Install the retaining screw.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.6 N.m (14 lb in).
3. Connect the electrical connector.
4. Install the center console end panel.
