Yukon/Denali 2WD V8-4.8L VIN V (2005)
7. Install the caliper and the bracket as an assembly to the vehicle.
8. Perform the following procedure before installing the caliper bracket mounting bolts.
^
Remove all traces of the original adhesive patch.
^
Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
^
Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
9. Install the caliper bracket mounting bolts.
^
Tighten the brake caliper bracket mounting bolts to 175 N.m (129 lb ft) (15 Series).
^
Tighten the brake caliper bracket mounting bolts to 300 N.m (221 lb ft) (25 Series).
Notice: Refer to Fastener Notice in Service Precautions.
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
11. Lower the vehicle.
12. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds, then repeat steps 12-13 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
15. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling.
