Yukon/Denali 2WD V8-4.8L VIN V (2005)
Brake Caliper: Service and Repair
Brake Caliper Replacement - Rear
1500 Series
Brake Caliper Replacement - Rear (1500 Series)
Removal Procedure
Caution: Refer to Brake Dust in Service Precautions.
Caution: Refer to Brake Fluid Irritant in Service Precautions.
1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level then no brake fluid needs to be removed from
the reservoir before proceeding.
3. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level then remove brake fluid to the
midway point before proceeding.
4. Raise and support the vehicle. Refer to Vehicle Lifting..
5. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
6. Compress the brake caliper pistons.
^
Install a large C-clamp over the top of the caliper housing and against the back of the outboard pad.
^
Slowly tighten the C-clamp until the pistons are pushed completely into the caliper bores.
^
Remove the C-clamp from the caliper.
7. Clean all dirt and foreign material from the brake hose end.
Important: Install a rubber cap or plug to the exposed brake pipe fitting end to prevent brake fluid loss and contamination.
8. Remove the brake hose to caliper bolt from the brake caliper.
9. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper housing or the brake hose end.
