Yukon/Denali 2WD V8-4.8L VIN V (2005)
Important: Install a rubber cap or plug to the exposed brake pipe fitting end to prevent brake fluid loss and contamination.
11. Remove the brake hose to caliper bolt from the brake caliper.
12. Remove the brake hose from the caliper.
13. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper housing or the brake hose end.
14. Loosen the brake caliper mounting bolts. Do not remove.
15. Remove the brake caliper mounting bracket bolts.
Caution: Do not depress the brake pedal with the brake rotors/calipers and/or the brake drums removed. Damage to the brake system may
result.
If brake system damage occurs and is not repaired, vehicle damage and/or personal injury or death may result.
16. Remove the brake caliper and the brake caliper mounting bracket as an assembly.
17. Remove the brake caliper mounting bolts.
18. Remove the brake caliper from the brake caliper mounting bracket.
19. Inspect the caliper assembly. Refer to Brake Caliper Inspection
