Yukon/Denali 2WD V8-4.8L VIN V (2005)
4. Install the cable taking care to correctly route the cable through the guides and the body mounts.
5. Install the cable to the backing plate by pressing the cable into place until locking tabs snap into place (25 series).
6. Attach the cable to the lever.
7. Install the cable to the track bar and secure with the clips. Verify that the clips are installed between the locators on the track bar (15 series).
8. Install the cable to the right and left side guides.
9. Install the cable to the mounting bracket until the locking tabs snap into place.
10. Bolt the cable to the differential (clips).
^
Tighten the bolt to 25 N.m (18 lb ft).
Notice: Refer to Fastener Notice in Cautions and Notices.
Important: After installing the cable to the rear axle holding clip, verify that clip is securely retaining the cable. If not, crimp the clip by hand
taking care not to pinch or kink the cable.
