Yukon/Denali 2WD V8-4.8L VIN V (2005)
6. Remove the safety stands.
7. Lower the vehicle.
Park Brake Cable Equalizer Replacement
Park Brake Cable Equalizer Replacement
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting..
3. Remove the nut from the threaded end of the intermediate cable.
4. Disconnect the equalizer from the rear park brake cables.
Installation Procedure
1. Connect the equalizer to the rear park brake cables.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the nut to the threaded end of the intermediate cable.
Tighten the nut to 3.5 Nm (31 inch lbs.).
3. Remove the safety stands.
4. Lower the vehicle.
5. Adjust the park brake system. Refer to Park Brake Adjustment.
