Yukon/Denali 2WD V8-4.8L VIN V (2005)
Parking Brake Pedal: Service and Repair
Park Brake Pedal Assembly Replacement
Park Brake Pedal Assembly Replacement
Removal Procedure
Caution: Refer to Battery Disconnect in Service Precautions.
1. Disconnect the negative battery cable.
2. Raise and support the vehicle. Refer to Vehicle Lifting..
3. Relieve the tension from the park brake cable by pulling down on the cable in front of the equalizer and removing the cable from the equalizer bar.
4. Remove the safety stands.
5. Lower the vehicle.
6. Remove the left side hinge pillar panel. Refer to Trim Panel Replacement - Hinge Pillar in Interior Trim.
7. Disconnect the park brake warning lamp connection.
8. Remove the MID-Bussed Electrical Center from the bracket.
9. Disconnect the park brake release cable from the park brake lever.
