Yukon/Denali 2WD V8-4.8L VIN V (2005)
-
Electronic suspension rear position sensor (1)
-
Rear shock (2)
5. If vehicle is equipped with RPO Z55, disconnect the following left side chassis harness electrical connectors:
-
Electronic suspension rear position sensor (1)
-
Rear shock (2)
Important: Do not attempt to pry the rear suspension sensor link rod from the rear position sensor ball stud.
6. Remove the left and right sensor link rods from the sensors, perform the following:
6.1.
Support the sensor lever with your hand
6.2.
Twist the link rod in order to remove it from the ball stud
7. Install adjustable jack stands under the rear axle.
8. Remove the rear axle vent hose from the rear axle, if necessary.
9. Remove the vent hose swivel clip from the rear brake crossover pipe.
