Yukon/Denali 2WD V8-4.8L VIN V (2005)
1. Install the mode actuator as an assembly with the actuator cam.
-
Line up the heater/defroster valve lever with the mode actuator cam slot.
-
Line up the A/C valve lever with the mode actuator cam.
2. Install the mode actuator mounting screw to the HVAC module.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screw to 1.6 N.m (14 lb in).
3. Connect the electrical connection at the mode actuator (10).
4. Install the floor air outlet duct extension (1) to the floor air duct (2).
Recirculation Actuator (Delphi)
RECIRCULATION ACTUATOR REPLACEMENT (DELPHI)
REMOVAL PROCEDURE
1. Remove the air distribution duct.
2. Disconnect the electrical connection from the recirculation actuator (1).
