Yukon/Denali 2WD V8-4.8L VIN V (2005)
4. Connect the electrical connector at the blower motor.
5. If equipped, install the sound insulator panel.
Blower Motor Processor Replacement - Auxiliary
BLOWER MOTOR PROCESSOR REPLACEMENT - AUXILIARY
REMOVAL PROCEDURE
1. Remove the right rear quarter trim panel.
2. Disconnect the electrical connector from the auxiliary blower motor processor (1).
3. Remove the retaining screws from the auxiliary blower motor processor (1).
4. Remove the auxiliary blower motor processor (1) from the auxiliary HVAC module (2).
INSTALLATION PROCEDURE
1. Install the auxiliary blower motor processor (1) to the auxiliary HVAC module (2).
2. Install the retaining screws to the auxiliary blower motor processor (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.6 N.m (14 lb in).
3. Connect the electrical connector to the auxiliary blower motor processor (1).
4. Install the right rear quarter trim panel.
HVAC Control Module Replacement - Auxiliary
HVAC CONTROL MODULE REPLACEMENT - AUXILIARY
REMOVAL PROCEDURE
