Yukon/Denali 2WD V8-4.8L VIN V (2005)
The number(s) below refer to the step(s) in the diagnostic table.
2. The chirping noise may not be engine related. This step is to verify that the engine is making the noise. If the engine is not making the noise do not
proceed any further in this table.
3. The noise may be an internal engine noise. Remove the drive belt(s) and operate the engine for a few seconds, this will verify if the chirping noise
is related to the drive belt(s) or not. With the drive belt(s) removed the water pump will not operate and the engine may overheat. Also diagnostic
trouble codes (DTCs) may set when the engine is operated with the drive belt(s) removed.
4. Inspect the drive belt(s) for signs of pilling. Pilling is the small balls, pills, or strings in the drive belt grooves caused by the accumulation of
rubber dust.
6. Misalignment of the accessory drive pulley(s) may be caused from improper mounting or incorrect installation of an accessory drive component,
or the pulley may be bent inward or outward from a previous repair. Test for a misaligned accessory drive pulley using a straight edge in the pulley
grooves across two or three pulleys. If a misaligned pulley is found, refer to that accessory drive component for the proper removal and installation
procedure for that pulley.
10. Inspection of the fasteners can eliminate the possibility that a incorrect bolt, nut, spacer, or washer was installed.
12. Inspection of the accessory drive pulley(s) should include inspecting for bends, dents, or other damage to the pulley(s) that would prevent the drive
belt(s) from seating properly in the pulley grooves or on the smooth surface of the pulley when the back side of the drive belt is used to drive the
pulley.
14. Replacing the drive belt(s) when it is not damaged or there is not excessive pilling will only be a temporary repair.
Drive Belt Excessive Wear
Drive Belt Excessive Wear Diagnosis
Diagnostic Aids
Excessive wear on a drive belt(s) is usually caused by incorrect installation or the incorrect drive belt(s) for the application.
Minor misalignment of the accessory drive pulley(s) will not cause excessive wear, but will probably cause the drive belt(s) to make a noise or fall off.
Excessive misalignment of the accessory drive pulley(s) will cause excessive wear and may also make the drive belt(s) fall off.
Test Description
