Yukon/Denali 2WD V8-4.8L VIN V (2005)
Power Steering Gear Inlet Pipe/Hose Replacement (Without Hydroboost)
Removal Procedure
1. Raise the vehicle.
2. Remove the engine protection shield.
Notice: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices.
3. Install a drain pan under the vehicle.
4. Remove the power steering gear inlet hose (3) from the power steering pump (1).
5. Remove the power steering gear inlet hose from the power steering gear.
6. Remove the power steering gear inlet hose from the vehicle.
Installation Procedure
Notice: Refer to Installing Hoses Without Twists or Bends Notice in Cautions and Notices.
1. Route the hose in the same position the hose occupied prior to removal.
2. Install the power steering gear inlet hose (3) to the power steering pump (1). Hand tighten only.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the power steering gear inlet hose to the power steering gear.
^
Tighten both power steering gear inlet hose fittings to 28 Nm (20 ft. lbs.).
4. Remove the drain pan from under the vehicle.
5. Install the engine protection shield.
6. Lower the vehicle.
7. Bleed the power steering system.
