Yukon/Denali 2WD V8-4.8L VIN V (2005)
Tighten the sensor nut to 7 Nm (62 lb in).
Important: Before reinstalling the tire on the wheel, note the following items to avoid tire pressure sensor damage upon tire mounting:
-
Position the mounting/dismounting head 180 degrees from the valve stem.
-
Position the bead transition area 45 degrees counterclockwise of the valve stem.
-
Using the tire machine, rotate the tire/wheel assembly clockwise when transferring the tire bead to the inside of the wheel rim.
Repeat items for outer bead.
4. Install the tire on the wheel. Refer to Tire Dismounting and Mounting.
Important: A service replacement tire pressure sensor is shipped in OFF mode. In this mode the sensor unique identification code cannot be
learned into the remote control door lock receiver (RCDLR) memory. The sensor must be taken out of OFF mode by spinning the tire/wheel
assembly above 32 km/h (20 mph) in order to close the sensors internal roll switch for at least 10 seconds.
5. Install the tire/wheel assembly on the vehicle.
6. Lower the vehicle.
7. Learn the tire pressure sensors. See: Tire Monitoring System/Service and Repair
