Yukon/Denali 2WD V8-4.8L VIN V (2005)
10. Remove the PCM.
Installation Procedure
1. Install the PCM.Ensure that the mounting tabs are engaged.
2. Secure the spring latch to the PCM.
3. Connect the PCM electrical connectors.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Tighten the PCM electrical connector bolts (2).
Tighten the bolts to 8 N.m (71 lb in).
5. Install the PCM cover.Ensure the mounting tabs are engaged into the mounting holes in the cover.
6. Connect the negative battery cable.
7. If a NEW PCM was installed, program the PCM. See: Testing and Inspection/Programming and Relearning
