Yukon/Denali 2WD V8-4.8L VIN V (2005)
5. Remove 2 TORX(R) head screws (1) from the lower trim cover (2).
6. Remove the lower trim cover (2).
7. Remove 2 TORX(R) head screws (2) from the upper trim cover (1).
8. Remove the upper trim cover (1).
9. Remove the wire harness straps from the steering wheel column wire harness.
10. Remove the retaining ring.
11. Disconnect the wire harness assembly from the base of the column.
12. Remove the SIR coil and wire harness assembly from the steering shaft.
13. If replacing, discard the SIR coil.
INSTALLATION PROCEDURE
1. Verify the following:
-
The wheels on the vehicle are straight ahead.
-
That J 42640 is installed or the ignition switch is in the LOCK position.
