Yukon/Denali 2WD V8-4.8L VIN V (2005)
NOTE:
-
The new SIR coil assembly will be centered. Improper alignment of the SIR coil assembly may damage the unit, causing an inflatable restraint
malfunction.
-
The wheels of the vehicle must be straight ahead and the steering column in the LOCK position before disconnecting the steering column or
intermediate shaft from the steering gear. Failure to do so will cause the SIR coil assembly to become uncentered, which may cause damage to the
coil assembly.
2. If reusing the existing coil it MUST be centered, refer to Inflatable Restraint Steering Wheel Module Coil Centering in Steering Wheel and
Column.
IMPORTANT: Do not remove the centering tab from the new SIR coil until the installation is complete. If the SIR coil does not come with a
centering tab, you MUST center the SIR coil.
3. Align the SIR coil assembly (1) with the horn tower on the turn signal cancel cam assembly and install onto the steering shaft.
4. Firmly seat the retaining ring (3) into the groove on the steering shaft assembly (2).
5. Remove and discard the centering tab from the new SIR coil.
6. Route the wire harness assembly around the column and install the wire harness straps.
7. Connect the connectors of the wire harness assembly.
8. Install the upper trim cover (1) and secure by using 2 TORX(R) head screws (2).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.5 N.m (13 lb in).
